Waterjet cutting using a thin high-pressure jet – a simple and very efficient separating technique for many materials.
The materials are separated by means of a high-pressure jet using pressure of up to 4,100 bar and a water-jet speed of up to 800 m/s. In case of hard materials, e.g. stainless steel, the water jet is combined with an abrasive, namely fine sand, so that the bonded material is separated. Due to this, a fissure size of less than 1 mm is possible, even when working with thick sheets.

Job order production 
A job order production of cuttings according to your design or the processing of your data are possible.

Inexpensive cutting technique
Waterjet cutting is used in order to manufacture inexpensively cuttings out of material such as stainless steel, steel, titanium, non-steel metals like aluminium as well as brittle material such as glass, ceramics, slabs of stones, even granite or marble, and additionally hard or soft plastic.


  • Minimal fissure size and fine surface structure of the cutting edges
  • No thermal change of material
  • No hardening of the cutting edge
  • No discolouration of surfaces
  • No environmental pollution caused by vapours, i.e. no peripheral gases when cutting


Technical specifications of the waterjet cutting system:
TCI Cutting SM-C 3015
Dimensions of the cutting table (L x W) 3000 x 1500 mm Z= 200 mm
High-pressure water pump 60 HP

TF Service offers a manufacturing service to make components to customer specifications.